Page tree
Skip to end of metadata
Go to start of metadata

Introduction

The Ubisecure SSO can be used as TUPAS IDP. This page describes how to set up TUPAS IDP in Ubisecure SSO.

About This Documentation

This page is a guide for configuring and using TUPAS integration in Ubisecure SSO and describes how an Ubisecure SSO Administrator can add and configure a TUPAS IDP.

Prerequisites

Before commencing, you need to know the redirect_uri address of the service to be connected and using TUPAS identification. This the address to which the successful TUPAS return message will be sent. Also the URL:s for exiting/canceling the identification are needed. These can be a same URL.
You also need to have a "site" created for the agent.

Standards and Recommendations Reference

Tupas identification service for service providers:

Documents above describe how the service should call TUPAS IDP (TUPAS requests), how TUPAS IDP responds (TUPAS return message/certificate), and how the request and response MAC codes are generated and validated – these issues are not covered in this Ubisecure's Confluence page.